Electrical Engineer

Posted 4/16/2026 · last confirmed live 9/5/2026

Job Summary We are seeking a hands-on Electrical Engineer for the development, integration, characterization, and troubleshooting of subsystem-level electrical testers. This role is highly technical and execution-focused, with a strong emphasis on practical hardware engineering. The ideal candidate should have 4–8 years of recent hands-on experience in designing and building electronics and semi-automated test systems, integrating hardware/software, and debugging complex electrical issues. Key Responsibilities Tester Development & Integration Design, build, and maintain subsystem characterization testers: Power distribution and protection Signal conditioning and measurement Control, interlocks, and safety circuits Develop custom test hardware (fixtures, wiring harnesses, test jigs) Integrate testers with: Mechanical fixtures Sensors, actuators, power electronics, embedded systems Lab and production environments Electrical Characterization & Debugging Perform subsystem electrical characterization: Voltage/current measurements Signal integrity and timing analysis Noise and grounding Troubleshoot issues in: Analog and digital electronics Power supplies, converters, motor drives Communication interfaces (I²C, SPI, UART, CAN, Ethernet, USB) Hands-On Lab Execution Execute testing in lab environments: Bring-up of testers and subsystems Debug under schedule pressure Support verification and troubleshooting Use lab equipment: Oscilloscopes, logic analyzers, DMMs, power analyzers Environmental and stress testing setups Required Qualifications Bachelor’s degree in Electrical/Mechanical Engineering or related field 4–8 years of hands-on experience in: Test system development Subsystem-level electrical integration & characterization Experience in: Analog & digital circuit design/debugging Power electronics (low-voltage/high-current systems) Strong troubleshooting skills using lab tools Experience across full lifecycle: concept → build → bring-up → support Strongly Preferred Embedded subsystems Motion control systems Sensor & transducer technologies Power distribution systems Communication protocols (CAN, Ethernet, RS-232, RS-485) Preferred Qualifications Medical device experience Familiarity with industry standards Exposure to PLM tools and change management EMI/EMC knowledge in harness design Key Skills Wire harness design & routing Electrical schematics interpretation NX Routing (3D harness design) Component selection & validation Strong analytical and communication skills

How your resume reads against this

What this posting states beside what your resume says. No match percentage: there is not an honest one to give.

This reads the resume you have in the editor, and this browser has none yet.

Open the editor and upload yours

Free, no account. It stays in this browser and is never stored on our side.

This role is published by Sapsol Technologies Inc on workable. SwiftFit is not the employer and does not accept applications.